Braun S32.533.5 Pulsonic SmartSeries Manuel d'utilisateur télécharger pdf (Page 14)

14

off during brushing. When pausing longer

than 30 seconds, the timer resets to the initial

starting point.

The «Count up Timer» displays your actual

brushing time. The «Count down Timer»

indicates the remaining brushing time. Starting

with «2:00» minutes, it goes down to «0:00».

When brushing longer than two minutes, it

automatically changes to the «Count up Timer».

The total brushing time can be extended to

3 minutes by using the «Extended Clean» mode

(see «Brushing modes» for more details).

Your toothbrush comes with the «Professional

Timer» and the «Count up Timer» activated. If

you wish to change these settings, proceed as

follows:

• Press and hold the brushing mode button (c)

for 3 seconds until the SmartGuide display

unit (i) shows «:30» and «timer».

• By briefly pressing the on/off button (b), switch

to the «2-Minute Timer». Confirm your choice

by pushing the mode button (c).

• This will lead you directly to the «Count up

Timer» display («up» and «timer» will be

shown). Switch to the «Count down Timer» by

pressing the on/off button and confirm it with

the mode button.

• To leave the setup menu press the mode

button again. The setup mode will be ended

automatically if no button is pressed for

60 seconds. Please note that all 3 pilot lights

are flashing while being in the setup menu.

SmartGuide display unit

Displayed

Icon

Meaning

«Daily Clean» mode

«Sensitiv» mode

«Massage» mode

«Polish» mode

«Extended Clean» mode

«Quadrant circle» – currently you

are brushing in the first 30-second

interval (45-second interval within

Extended Clean mode). Move to

the next quadrant of your mouth,

when the second segment starts

flashing.

Dentist recommended 2-minute

brushing time (3-minute brushing

time within the Extended Clean

mode) has been reached.

The rechargeable battery of the

handle is low. Charge the

toothbrush handle.

Batteries of the SmartGuide

display unit are low. Change

batteries of the SmartGuide

display unit.

Wall mount

If you prefer to mount the SmartGuide display

unit on a wall, mirror or other surface, use the

adhesive tape (k) to fix the wall mount (j). Before

doing so, make sure the chosen surface is clean

and dry (remove grease and dust first). Position

the wall mount so, that the Oral-B logo is

readable. Then, press the wall mount evenly and

firmly to the wall. Wait 24h before sliding the

3 sec.3 sec.

99404877_S_32_WE 14 06.05.2010 13:24:24 Uhr

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 79 80

Commentaires sur ces manuels

Pas de commentaire