Braun 5646 Manuel d'utilisateur télécharger pdf (Page 15)

Quick cleaning

Press the foil release buttons (12) to lift the shaver foil

(do not remove the foil completely). Switch on the shaver

for approx. 5–10 seconds so that the shaved stubbles can

fall out.

Thorough manual cleaning

Manual cleaning is recommended only when the

Clean&Renew™ station is not available, e.g. when travel-

ling.

Never use water to clean the shaver.

Remove the shaver foil and tap it out on a flat surface.

Using the brush, clean the inner area of the pivoting head.

However, do not clean the shaver foil nor the cutter block

with the brush as this may damage them.

If you do not use the Clean&Renew™ station for a longer

period of time, you should apply a drop of light machine

oil onto the shaver foil.

Cleaning the housing

Clean the housing of shaver and station from time to time

with a damp cloth, especially inside the opening of the

station where the shaver rests.

Replacing the cartridge

After having pressed the lift button (4) to open the

housing, wait for a few seconds before removing the used

cartridge.

Before discarding the used cartridge, make sure to close

the openings using the lid of the new cartridge, since the

used cartridge will contain contaminated cleaning

solution.

The shaver display

1. Pilot light: the shaver is connected to the mains.

2. Shaver is charging / Remaining charging time.

3. Self testing / shaver is fully charged (a full charge

will give up to 50 minutes of cordless shaving time,

depending on your beard growth).

fix

off

old

new

8995

5646449_8995_KO_CH Seite 15 Dienstag, 14. November 2006 4:06 16

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Pas de commentaire

Braun 5646 Manuel d'utilisateur Page 15